ALLIANCE AE7133 Manuel de service Page 68

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 125
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 67
60549 67
Section 8 Service Procedures Unique to Electronic Control Model Dryers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the dryer(s) before servicing.
Close gas shut-off valve to gas dryer(s) before servicing.
Never start the dryer(s) with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC DO NOT COPY or TRANSMIT
64. DRYER OPERATION
Press one of the ON/SELECT pads to select a
cycle which is appropriate for the type of fabric
being dried: REGULAR, PERM PRESS,
DELICATES, KNITS and NO HEAT. These are
automatic, preprogrammed cycles. A light to the
left of the pad lights up to show pad has been
activated.
Press the GO pad. The dryer will start
immediately and stop automatically when the
cycle has completed. Dryer will not start until the
GO pad is pressed.
NOTE: When you have selected an automatic cycle,
you will see the letters AU appear in the display
area.
TO STOP THE DRYER AT ANY TIME Open
dryer door or press the STOP pad.
TO RESTART DRYER Close door, select a cycle
if necessary and press the GO pad. The dryer will
not operate if the dryer door is open.
65. STATUS LIGHTS
The STATUS lights illuminate to show you at a
glance what is happening inside your dryer.
66. GO, STOP AND RESET
GO
Press the GO pad to start the dryer. The dryer will
not run until the GO pad is pressed.
STOP
Press the STOP pad to stop the dryer at any point
in the cycle. The dryer will remain at that portion
of the cycle until the GO pad is again pressed. At
that time, the cycle will continue where it left off.
Pressing the STOP pad two times in succession
will completely turn the control off.
RESET
Press the RESET pad two times in succession to
cancel any cycle or completely turn the dryer off.
67. AUTOMATIC CYCLES
Depending on the model of dryer you have, it may
or may not have all of the following cycles and
features.
By pressing REGULAR, PERM PRESS,
DELICATES or KNITS, the Normal Automatic
Dryness Level will be selected. With the correct
cycle chosen, the dryer will determine the exact
length of drying time. When the clothes are dry,
the dryer will go into the cool-down portion of the
cycle. The length of cool-down will vary
according to which cycle is chosen.
68. NO-HEAT CYCLE
This is a no-heat cycle that tumbles and circulates
room temperature air through the load. Use for
any items that should not be dried with heat.
A preprogrammed 20-minute cycle is
automatically chosen for you. Time can be added
or subtracted by using the MORE or LESS pads.
Clean
Filter
Will flash before each cycle to remind
you to clean the dryers lint filter
before each load. A clean lint filter
promotes faster drying and energy
savings.
Drying Remains lit while your clothes are
drying.
Cool-
Down
Lights up during the cool-down
portion of the cycle.
Wrinkle-
Free
(available
on some
models)
Lights up during the wrinkle-free
portion of the cycle when the wrinkle-
free option has been selected. Clothes
may be removed from the dryer at any
time during the wrinkle-free portion.
Vue de la page 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 124 125

Commentaires sur ces manuels

Pas de commentaire