ALLIANCE AE7133 Manuel de service Page 42

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 125
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 41
60549 41
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the dryer(s) before servicing.
Close gas shut-off valve to gas dryer(s) before servicing.
Never start the dryer(s) with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC DO NOT COPY or TRANSMIT
To Test Drive Motor:
Refer to Figure 25
1. Remove motor and exhaust assembly.
2. Disconnect wires from motor switch.
NOTE: Refer to appropriate wiring diagram
when rewiring motor switch.
3. Put test meter probes on terminals 4 and 5. Meter
should read approximately one on Ohm scale.
4. Put test meter probes on terminal 4 and motor
frame. Meter should register no reading or
infinite.
5. Put test meter probes on terminal 5 and motor
frame. Meter should register no reading or
infinite.
6. Put test meter probes on terminals 4 and 6. Meter
should register no reading or infinite.
Manually flex the centrifugal switch in motor,
meter should read approximately two on Ohm
scale.
7. Put test meter probes on terminals 1 and 2. Meter
should register no reading. Manually flex the
centrifugal switch in motor, meter should read
zero Ohms.
Figure 25
DRY956S
2
1
6
4
5
2
1
6
5
4
MOTOR AND
EXHAUST
ASSEMBLY
DRIVE
MOTOR
GROUND
WIRE
MOTOR
SWITCH
Vue de la page 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 124 125

Commentaires sur ces manuels

Pas de commentaire