ALLIANCE AE7133 Manuel de service Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 125
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
60549 27
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the dryer(s) before servicing.
Close gas shut-off valve to gas dryer(s) before servicing.
Never start the dryer(s) with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC DO NOT COPY or TRANSMIT
30. INNER AND OUTER DOOR PANELS AND
DOOR HANDLE
a. Remove four screws holding hinges to door.
Refer to Figure 10.
b. Remove screws holding handle to door and
separate panels. Refer to Figure 11.
IMPORTANT: Do not over-tighten screws when
reinstalling door handle and avoid scratching inner
door panel.
31. DOOR STRIKER
Refer to Figure 11
a. Remove two screws holding handle to door.
b. Spread door panels just far enough to depress
tabs on top and bottom of striker and push out
of inner panel.
32. DOOR SEAL
Open loading door and remove seal from inner
door panel.
NOTE: When replacing seal, be sure seal is not
stretched or distorted. Use a heat resistant adhesive
(such as Krazy Glue
) to adhere door seal to inner
door panel.
Figure 11
DRY850S
DOOR
SEAL
DOOR
STRIKER
HEX HEAD
SCREW
INNER
DOOR PANEL
DOOR
HANDLE
OUTER
DOOR PANEL
DOOR
ASSEMBLY
SPEED
NUT
PHILLIPS HEAD
SCREW
DOOR
HINGE
PHILLIPS HEAD
SCREW
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 124 125

Commentaires sur ces manuels

Pas de commentaire